Cannot be bypassed

Sensor wires always clear of production area: Sensor wires are connected at output of welder secondary. Never needs sensor wire location to be moved closer to the electrodes for any type of welder. 

Fast Release: Electrodes close under low force and release in less than half of a second if metal is not detected between electrodes. 

Electrodes close without initial delay: Electrodes start to move at the same time the welding control is initiated. Closing speed is independent of welding pressure. 

Works with ram depth limit switch: For redundant system requiring both electrode continuity and ram depth limit switch closure.











NEW FEATURES:

Easier Setup: No user calibration, EVER. Just install and turn power ON. 

Universal: Works with Non-Unitrol MFDC inverter and 1 phase AC controls. Change two plug-in relays for use with 115VAC or 24VDC solenoid valve voltage. 

Always ready to protect: Does not have to be calibrated even when you power-up, change material or change tooling.

Instantly tunes to your welder: Does not stop production to recalibrate. Automatically compensates for changes in transformer tap switch position or line voltage shifts. 

New Look: Easy-to-read operation display. Shows exactly what is happening. Can be mounted on either side of enclosure. 

Supports Soft Touch Retract: Just add optional retract pneumatic system with head down limit switch for full protection

Full Electrical Redundancy: All inputs and outputs require closure of both electro mechanical and solid state redundant components for full safe operation. Self-monitors output relay to prevent any operation if a fault is detected. 

Cannot be bypassed

Sensor wires always clear of production area: Sensor wires are connected at output of welder secondary. Never needs sensor wire location to be moved closer to the electrodes for any type of welder. 

Fast Release: Electrodes close under low force and release in less than half of a second if metal is not detected between electrodes. 

Electrodes close without initial delay: Electrodes start to move at the same time the welding control is initiated. Closing speed is independent of welding pressure. 

Works with ram depth limit switch: For redundant system requiring both electrode continuity and ram depth limit switch closure.

NEW FEATURES:

Easier Setup: No user calibration, EVER. Just install and turn power ON. 

Universal: Works with Non-Unitrol MFDC inverter and 1 phase AC controls. Change two plug-in relays for use with 115VAC or 24VDC solenoid valve voltage. 

Always ready to protect: Does not have to be calibrated even when you power-up, change material or change tooling.

Instantly tunes to your welder: Does not stop production to recalibrate. Automatically compensates for changes in transformer tap switch position or line voltage shifts. 

New Look: Easy-to-read operation display. Shows exactly what is happening. Can be mounted on either side of enclosure. 

Supports Soft Touch Retract: Just add optional retract pneumatic system with head down limit switch for full protection

Full Electrical Redundancy: All inputs and outputs require closure of both electro mechanical and solid state redundant components for full safe operation. Self-monitors output relay to prevent any operation if a fault is detected. 

 Does your company meet OSHA safety standards? Protect your resistance welder operators from serious finger injury or amputation by installing a safety system on your welders. JANDA is a master distributor of Soft Touch Safety Systems and has qualified engineers for installation. Inquire today for more information.

FEATURES: